Installing the Drive Belt
Hydraulic System: Service and Repairs
(Figure
65) (continued)
Use caution when installing torsion spring end onto the pump mount
plate. Applying tension to the spring may cause personal injury
during installation.
4. Apply pump drive belt tension with torsion spring on idler arm
A. Insert nut driver or small piece of pipe onto the end of the torsion spring.
B. Push down on the spring end and then hook the spring under the tab
on the pump mount plate.
5. Lubricate the grease fitting on end of idler pivot shaft.
6. Lower and secure hood.
CAUTION
Page 5–76
(Figure
66).
Reelmaster
®
3100-D/3105-D
20252SL Rev A