Reel Assembly - Toro Greensmaster 1018 Service Manual

Reel Assembly

g261490
1. Expansion plug
2. Bearing lock screw
3. Socket head screw (2 each)
4. LH side plate
5. Flat wire spring
6. Sealed bearing (2 each)
Removing the Reel Assembly
DPA Cutting Units: Service and Repairs
7. Seal (2 each)
8. Reel assembly
9. Frame support rod
10. RH side plate
11. Reel drive nut
12. V ring seal
This section provides the procedure for removing and installing the reel assembly
(reel, reel bearing, bearing lock screw, reel nut and seals) from the cutting unit.
Note: Refer to Figure 78
1. Park the machine on a level surface. Ensure that the engine is OFF and
the traction control is in NEUTRAL.
2. Remove the spark plug wire from the engine spark plug.
3. If the cutting unit is equipped with an optional groomer, remove the drive
components for those options from cutting unit. Refer to
Box Assembly (page 9–4)
(page 2–5) for additional information.
4. Remove the cutting unit assembly from the frame assembly; refer to
Removing the Cutting Unit Assembly (page
5. Remove the reel drive assembly; refer to
(page 5–7).
6. Remove the bedbar; refer to
7. Remove the front roller; refer to
Figure 78
13.
14.
15.
16.
17.
18.
during this procedure.
for universal groomer, and
Removing the Reel Drive Assembly
Removing the Bedbar (page
Removing the Front Roller (page
Page 8–18
Drive spline
Frame support rod
Washer (2 each)
Bolt (2 each)
Socket head screw (2 each)
Grass shield assembly
Removing the Gear
Universal Groomer
8–16).
8–7).
8–24).
Greensmaster ® 1018/1021/1026
18238SL Rev B