Toro Reelmaster 3100-D Service Manual page 372

Assembling the Groomer Reel (continued)
g220499
1. Groomer reel
2. Broomer strap (4 each)
Universal Groomer (Optional): Service and Repairs
4. Using through holes in shaft to prevent shaft from rotating, tighten second
lock nut from 42 to 48 N·m (31 to 35 in-lb). After tightening lock nut, spacers
should not be free to rotate and groomer blades should be centered on shaft.
5. If groomer reel is equipped with broomer kit:
A. Loosen the groomer blade retaining nuts on each end of the groomer
shaft.
B. Slide a brush into each groove around the full length of the groomer reel
(Figure 216). Make sure that the brushes are seated in groomer blade
slots (Figure 216).
The straps must be wrapped around the groomer blade and brush
assembly in the correct direction.
C. Loosely wrap the straps around the groomer reel shaft and brushes as
shown (Figure 216). Straps should be positioned in the pre-cut notches
of each brush and at the following locations on the broomer shaft:
18" reels - between blades 2-3, 11-12, 21-22 and 30-31.
22" reels - between blades 2-3, 14-15, 26-27 and 38-39.
Position the broomer brushes properly in the blade slots, and tighten the
groomer blade-retaining nuts from 42 to 48 N·m (31 to 35 ft-lb).
D. While holding strap buckle in place, pull straps tight into the pre-cut
notches of each brush.
E. Cut off strap extension approximately 6mm (1/4 in) beyond retainer and
fold the excess strap over the buckle
6. Install O-ring on non-drive end of groomer shaft.
7. Install groomer reel back on cutting unit (refer to
(page 9–16)).
Figure 216
3. Blade
4. Brush
IMPORTANT
(Figure
Page 9–18
216).
Installing the Groomer Reel
Reelmaster ® 3100-D/3105-D
20252SL Rev A