Service And Repairs; Hydraulic Reel Motor - Toro Reelmaster 3100-D Service Manual

Service and Repairs

Hydraulic Reel Motor

Removing the Hydraulic Reel Motor
Installing the Hydraulic Reel Motor
DPA Cutting Units: Service and Repairs
When performing the maintenance procedures on the cutting units,
carefully position the cutting unit reel motors to prevent damage to
the motors or hydraulic hoses.
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, shut off the engine, set the parking brake, and
remove the key from the key switch.
2. Loosen the two (2) cap screws that secure the hydraulic reel motor to the
cutting unit side plate. Rotate the motor clockwise and remove the motor
from the cutting unit.
3. Inspect the reel insert splines for wear. Replace if necessary (refer to
Assembly (page 8–19)).
4. Place protective plastic cap (refer to
in the cutting unit side plate to prevent debris entry into reel bearing area.
g343373
1. Reel motor location
Note: Refer to Figure 165
and weights.
1. Coat spline shaft of the reel motor with No. 2 multipurpose lithium base
grease.
2. Install the cap screws for the reel drive motor into the cutting unit side plate
and leave approximately 12.7 mm (1/2 inch) of threads exposed on each
screw.
IMPORTANT
Special Tools (page
Figure 165
2. Weight location
for correct placement of the cutting unit reel motors
Page 8–6
Reel
2–13)) into the hole
Reelmaster ® 3100-D/3105-D
20252SL Rev A