Toro Reelmaster 3100-D Service Manual page 368

Removing the Idler Assembly (continued)
Installing the Idler Assembly
Universal Groomer (Optional): Service and Repairs
6. Inspect shields, bearing and bushing in idler assembly. Remove and discard
damaged or worn components.
1. If shields, bearing or bushing was removed from idler arm, install new
components.
A. Press bushing into groomer plate until the bushing is centered in the
idler arm bore.
B. Press bearing into idler arm so that bearing contact shoulder in idler arm
bore and install bearing retaining ring.
C. Install bearing shields with flocked side of shield toward bearing.
D. Verify idler arm orientation (LH or RH cutting unit) and insert stub shaft
through shields and bearing. Using through hole in shaft to prevent shaft
from rotating, tighten flange nut from 37 to 45 N·m (27 to 33 ft-lb).
E. If collar was removed from idler arm, install collar and tighten from 33
to 41 N·m (24 to 30 ft-lb).
g343765
1. Pivot hub
2. Apply anti-sieze lubricant to the outside diameter of the pivot hub
213). Position idler arm over pivot hub.
3. Apply Loctite to two (2) socket head screws and secure pivot hub and idler
arm to cutting unit side plate.
4. Use a new cotter pin and install the cotter pin and clevis pin securing the
height adjustment rod to the front of the idler arm.
5. Install the groomer reel assembly (refer to
9–16)).
6. Install the hydraulic reel motor to cutting unit (refer to
Reel Motor (page 8–6)).
Figure 213
Installing the Groomer Reel (page
Page 9–14
(Figure
Installing the Hydraulic
Reelmaster ® 3100-D/3105-D
20252SL Rev A