Reel Assembly - Toro Greensmaster Flex 1800 Service Manual

Reel Assembly

8
10
12
11
7
RIGHT
FRONT
1. Crossmember
2. LH side plate
3. Compression spring (2 used)
4. Shoulder bolt (2 used per side plate)
5. Flange nut (2 used per side plate)
NOTE: This section provides the procedure for remov-
ing and installing the cutting reel assembly (cutting reel,
flocked seals, reel bearings, bearing lock screw and reel
nut) from the cutting unit. Refer to Cutting Reel Assem-
bly Service in this section for information on servicing
the cutting reel assembly.
Cutting Unit
210 to 240 in- lb
(24 to 27 N- m)
4
9
5
3
6
6. Cutting reel assembly
7. RH pitch arm
8. Flange head screw (2 used)
9. RH side plate
10. Weight
13
5
5
15
Figure 27
NOTE: Flex 2100/2120 cutting units use shoulder bolts
(item 4) and flange nuts (item 5) to secure the side plates
to the crossmember as shown in Figure 27. On Flex
1800/1820 cutting units, square nuts are used instead
of flange nuts. Cutting unit service procedures are the
same on both models.
Page 7 - 18 Greensmaster Flex 1800/1820/2100/2120
Flex 2100/2120 Shown
210 to 240 in- lb
(24 to 27 N- m)
1
5
2
14
3
11. Hex nut
12. O- ring
13. Grass shield
14. Flat wire spring
15. LH pitch arm
4