Notify Surveillance Center - HIKVISION DS-2TD2137-7P User Manual

DS-2TD2137-7P Thermal Network Camera User Manual
when an alarm event is detected.
For e-mail settings, refer to Set Email.
Set Email
When the e-mail is configured and Send Email is enabled as a linkage method, the device sends an e-mail
notification to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the Email function. Go to Configuration → Network → Basic Settings → TCP/IP
for DNS settings.
Steps
1. Go to the E-mail settings page: Configuration → Network → Advanced Settings → Email.
2. Set e-mail parameters.
1) Input the sender's e-mail information, including Sender's Address, SMTP Server, and SMTP Port.
2) Optional: If your e-mail server requires authentication, check Authentication and input your user
name and password to log in to the server.
3) Set the E-mail Encryption.
• When you select SSL or TLS, and disable STARTTLS, e-mails are sent after being encrypted by
SSL or TLS.The SMTP port should be set to 465.
• When you select SSL or TLS and Enable STARTTLS, e-mails are sent after being encrypted by
STARTTLS, and the SMTP port should be set to 25.
NOTE:
If you want to use STARTTLS, make sure that the protocol is supported by your e-mail
server. If you check Enable STARTTLS and the protocol is not supported by your e-mail
sever, your e-mail will be sent with no encryption.
4) Optional: If you want to receive notification with alarm pictures, check Attached Image.The
notification e-mail has three attached alarm pictures about the event with configurable image
capturing interval.
5) Input the receiver's information, including the receiver's name and address.
6) Click Test to see if the function is properly configured.
3. Click Save.

Notify Surveillance Center

Check Notify Surveillance Center, the alarm information is uploaded to the surveillance center when an
alarm event is detected.
UM DS-2TD2137-7P 042021NA 34