DS-2TD2137-7P Thermal Network Camera User Manual
Set ONVIF
If you need to access to the device through ONVIF protocol, you can configure the ONVIF user to enhance
the network security.
Steps
1. Go to Configuration → Network → Advanced Settings → Integration Protocol.
2. Check Enable ONVIF.
3. Click Add to configure the ONVIF user.
•
Delete: Delete the selected ONVIF user.
•
Modify: Modify the selected ONVIF user.
4. Click Save.
5. Optional: Repeat the steps above to add more ONVIF users.
Set HTTP Listening
The device can send alarms to destination IP or host name through HTTP protocol. The destination IP or
host name should support HTTP data transmission.
Steps
1. Go to Configuration → Network → Advanced Settings → HTTP Listening.
2. Input Destination IP or Host Name, URL, and Port.
3. Click Test.
NOTE:
Click Default to reset the destination IP or host name.
4. Click Save.
UM DS-2TD2137-7P 042021NA
60