Table of Contents
Advertisement
Thermal Optical Bi-spectrum Network Camera User Manual
When you select SSL or TLS, and disable STARTTLS, emails are sent after encrypted by SSL or
●
TLS. The SMTP port should be set as 465.
When you select SSL or TLS and Enable STARTTLS, emails are sent after encrypted by
●
STARTTLS, and the SMTP port should be set as 25.
Note
If you want to use STARTTLS, make sure that the protocol is supported by your email server.
If you check the Enable STARTTLS while the protocol is not supported by your email sever,
your email is sent with no encryption.
4) Optional: If you want to receive notification with alarm pictures, check Attached Image. The
notification email has a certain number of attached alarm pictures about the event with
configurable image capturing interval.
Note
The number of alarm pictures may vary according to different device models and different
events.
5) Input the receiver's information, including the receiver's name and address.
6) Click Test to see if the function is well configured.
3. Click Save.
9.2.4 Notify Surveillance Center
Check Notify Surveillance Center, the alarm information is uploaded to the surveillance center
when an alarm event is detected.
9.2.5 Trigger Recording
Check Trigger Recording, and the device records the video about the detected alarm event.
For device with more than one camera channels, you can set one or more channels to take
recordings if needed.
For recording settings, refer to Video Recording and Picture Capture .
9.2.6 Set Audible Alarm Output
When the device detects targets in the detection area, audible alarm can be triggered as a
warning.
Steps
1. Go to Configuration → Event → Basic Event → Audible Alarm Output .
2. Select an Alarm Type.
3. Select Sound Type and set related parameters.
- Select Warning and its contents. Set the alarm times you need.
67
Advertisement
Table of Contents
