Table of Contents
Advertisement
DS-2TD2137-7P Thermal Network Camera User Manual
Set Manual Port Mapping
Steps
1. Check Enable UPnP™, and choose a friendly name for the device, or use the default name.
2. Set the port mapping mode to Manual, and set the external port to be the same as the internal port.
3. Click Save.
What To Do next
Go to the router port mapping settings interface and set the port number and IP address to be the same as
those on the device. For more information, refer to the router user manual.
Multicast
Multicast is group communication where data transmission is addressed to a group of destination devices
simultaneously. After setting multicast, you can send the source data efficiently to multiple receivers.
Go to Configuration → Network → Basic Settings → Multicast for the multicast settings.
•
IP Address: The multicast host address
Stream Type: The stream type as the multicast source
•
Video Port: The video port of the selected stream
•
•
Audio Port: The audio port of the selected stream
SNMP
Set the SNMP protocol for alarm event and exception messages in network transmission.
Before You Start
Download SNMP software and manage to receive device information via the SNMP port.
Steps
1. Go to the settings page: Configuration → Network → Advanced Settings → SNMP.
2. Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
NOTE:
The SNMP version you select should be the same as that of the SNMP software.
Use the version based on the security level required. SNMP v1 is not secure, and
SNMP v2 requires a password for access. SNMP v3 provides encryption and requires
HTTPS protocol be enabled.
3. Configure the SNMP settings.
4. Click Save.
UM DS-2TD2137-7P 042021NA
56
Advertisement
Table of Contents
