Enable Hik-Connect Service On Camera; Enable Hik-Connect Service Via Web Browser; Enable Hik-Connect Service Via Sadp Software - HIKVISION DS-2TD2137-7P User Manual

DS-2TD2137-7P Thermal Network Camera User Manual
4. Click Save.
5. Access the device.
•
By Browser: Enter the WAN dynamic IP address in the browser address bar to access the device.
•
By Client Software: Add the WAN dynamic IP address to the client software. Refer to the client
manual for details.
NOTE: The obtained IP address is dynamically assigned via PPPoE, so the IP address always
changes after rebooting the camera.To solve the inconvenience of a dynamic IP,
obtain a domain name from a DDNS provider (e.g., DynDns.com). Refer to Access to
Device via Domain Name for detailed information.

Enable Hik-Connect Service on Camera

Enable Hik-Connect service on your camera before using the service. You can enable the service through
SADP software or a Web browser.

Enable Hik-Connect Service via Web Browser

Follow the following steps to enable Hik-Connect Service via a Web Browser.
Before You Start
You need to activate the camera before enabling the service.
Steps
1. Access the camera via a Web browser.
2. Enter platform access configuration interface, Configuration → Network → Advanced Settings → Platform
Access.
3. Select Hik-Connect as the Platform Access Mode.
4. Check Enable.
5. Click and read "Terms of Service" and "Privacy Policy" in the pop-up window.
6. Create a verification code or change the old verification code for the camera.
NOTE: The verification code is required when you add the camera to Hik-Connect service.
7. Save the settings.

Enable Hik-Connect Service via SADP Software

This section introduces how to enable Hik-Connect service via SADP software of an activated camera.
UM DS-2TD2137-7P 042021NA 58