HIKVISION DS-2TD2137-7P User Manual page 19

DS-2TD2137-7P Thermal Network Camera User Manual
•
Dynamic Fire: Detect the fire source in the scene.
•
Sensitivity: The sensitivity of fire detection. The bigger the value, the more easily the fire source
can be detected, and the false rate is higher.
NOTE: When VCA Resource Type is selected as Temperature Measurement+Behavior
Analysis, only smoking detection is supported. When VCA Resource Type is selected
as Temperature Measurement+Fire Detection, both detection modes are supported.
6. Check Display Fire Source Frame on Stream to display a red frame around the fire source on stream
when fire occurs.
7. Optional: You can shield certain areas from being detected in fire source detection.
1) Go to Configuration → Event → Smart Event → Fire Source Detection Shield.
2) Check Enable Fire Source Detection Shield.
3) Click Draw Area and drag the mouse in the live view to draw the area. Release the mouse to finish
drawing.
4) You can drag the corners of the red rectangle area to change its shape and size, or drag the
rectangle to the position on demand.
5) Click Stop Drawing.
6) Click Clear All to clear all of the setting areas.
7) Set the value of Active Zoom Ratio on demand, and then the shield will appear only when the zoom
ratio is greater than the predefined value
8) Click Add to save the smoke detection shield, and it will be listed in the Fire Source Detection Shield
List area; you can select a region and click Delete to delete it from the list; you can also define the
color of the regions.
9) Check Display Shield Region to show the shielded area in live view.
8. Refer to Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for setting
linkage method.
9. Click Save.
UM DS-2TD2137-7P 042021NA 19