Table of Contents
Advertisement
DS-2TD2137-7P Thermal Network Camera User Manual
Port
The device port can be modified if the device cannot access the network due to port conflicts.
CAUTION:
Do not modify the default port parameters at will, otherwise the device may be
unaccessible.
Go to Configuration → Network → Basic Settings → Port for port settings.
HTTP Port: The port that accesses the device through a browser. Enter the port no. after the IP address.
•
For example, if the HTTP port is modified to 81, enter
login.
HTTPS Port: The port for browser certificate access. Certificate verification is required when accessing
•
the device through a browser and the security level is high.
RTSP Port: The real time streaming protocol port.
•
•
Server Port: The port on which the client adds the device.
Port Mapping
By setting port mapping, you can access devices through the specified port.
Before You Start
When the device ports are the same as those of other devices on the network, refer to Port to modify the
device ports.
Steps
1. Go to Configuration → Network → Basic Settings → NAT.
2. Select the port mapping mode.
•
Auto Port Mapping: Refer to
•
Manual Port Mapping: Refer to
3. Click Save.
Set Auto Port Mapping
Steps
1. Check Enable UPnP™, and choose a friendly name for the camera, or use the default name.
2. Select the port mapping mode to Auto.
3. Click Save.
NOTE:
UPnP™ function on the router should be enabled at the same time.
UM DS-2TD2137-7P 042021NA
http://192.168.1.64:81
Set Auto Port Mapping
Set Manual Port Mapping
for detailed information.
for detailed information.
in the browser for browser
55
Advertisement
Table of Contents
