Table of Contents
Advertisement
DS-2TD2137-7P Thermal Network Camera User Manual
Chapter 2 Device Activation and Accessing
To protect the security and privacy of the user account and data, set a login password to activate the
device when accessing the device via a network.
NOTE:
See the software client user manual for details about client software activation.
Activate the Device via SADP
Search and activate online devices via SADP software.
Before You Start
Access www.hikvision.com to get the SADP software to install.
Steps
1. Connect the device to a network using the network cable.
2. Run SADP software to search for online devices.
3. Check Device Status from the device list, and select Inactive device.
4. Create and input a new password in the password field, and confirm the password.
STRONG PASSWORD RECOMMENDED − We highly recommend that you create a strong
password of your own choosing (using a minimum of eight characters, including at least
three of the following categories: upper case letters, lower case letters, numbers, and
special characters) in order to increase the security of your product. We also recommend
that you reset your password regularly. Especially in high security systems, resetting the
password monthly or weekly can better protect your product.
Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
5. Click OK.Device Status changes into Active.
6. Optional: Change the device network parameters in Modify Network Parameters.
Activate the Device via Browser
You can access and activate the device via a browser.
Steps
1. Connect the device to a PC using the network cables.
2. Change the IP address of the PC and device to the same segment.
NOTE:
The default IP address of the device is 192.168.1.64.You can set the IP address of the
PC from 192.168.1.2 to 192.168.1.253 (except 192.168.1.64). For example, you can set
the PC IP address to 192.168.1.100.
UM DS-2TD2137-7P 042021NA
11
Advertisement
Table of Contents
