DS-2TD2137-7P Thermal Network Camera User Manual
Chapter 6 Event and Alarm
This part introduces events configuration. The device takes certain response to a triggered alarm.
Set Motion Detection
It helps to detect the moving objects in the detection region and trigger the linkage actions.
Steps
1. Go to Configuration → Event → Basic Event → Motion Detection.
2. Check Enable Motion Detection.
3. Optional: Highlight to display the moving object in the image in green.
1) Check Enable Dynamic Analysis for Motion.
2) Go to Configuration → Local.
3) Set Rules to Enable.
4. Select Configuration Mode, and set rule region and rule parameters.
•
For information about normal mode, see
•
For information about expert mode, see
5. Set the arming schedule and linkage methods. For the information about arming schedule settings,
see Set Arming Schedule. For the information about linkage methods, see Linkage Method Settings.
6. Click Save.
Normal Mode
You can set motion detection parameters according to the device default parameters.
Steps
1. Select normal mode in Configuration.
2. Set the normal mode sensitivity. The higher the sensitivity value, the more sensitive the motion
detection. If the sensitivity is set to 0, motion detection and dynamic analysis do not take effect.
3. Click Draw Area. Click and drag the mouse on the live video, then release the mouse to finish drawing
one area.
UM DS-2TD2137-7P 042021NA
Normal Mode
.
Expert Mode
.
26