Chapter 7 Event And Alarm; Basic Event; Set Motion Detection - HIKVISION DS-2DE5425IWG-4G User Manual

This part introduces the configuration of events. The device takes certain response to triggered
alarm. Certain events may not be supported by certain device models.

7.1 Basic Event

7.1.1 Set Motion Detection

This function detects moving objects in the detection region and trigger linkage actions.
Steps
1. Go to Configuration → Event → Event and Detection → Motion Detection .
2. Check Enable.
3. Optional: (Only available in PTZ channel) Check Enable Motion Detection in PTZ Control, and
the device detects moving targets in PTZ movement.
4. Optional: Highlight moving objects in green.
1) Check Enable Dynamic Analysis for Motion.
2) Go to Configuration → Local to enable Rules.
5. Select configuration mode. Normal mode and expert mode are selectable.
- For the information about normal mode, see Normal Mode .
- For the information about expert mode, see Expert Mode .
6. Set the arming schedule. See Set Arming Schedule for details.
7. Set linkage methods. See Linkage Method Settings for details.
8. Click Save.
Normal Mode
You can set motion detection parameters according to the device default parameters.
Steps
1. Select Normal Mode in Configuration.
2. Set the Sensitivity of normal mode. The higher the value of sensitivity is, the more sensitive the
motion detection is. If the sensitivity is set to 0, motion detection and dynamic analysis do not
take effect.
3. Set Detection Target. Human and vehicle are available. If the detection target is not selected, all
the detected targets will be reported, including the human and vehicle. This function allows
alarm triggering by specified target types (human and vehicle).
Network Speed Dome User Manual

Chapter 7 Event and Alarm

45