Character Deactivation; Deactivation Character; Illumination Lights - Honeywell HH490 User Manual

Character Deactivation

If you have sent a character from the host to trigger the scanner to begin
scanning, you can also send a deactivation character to stop scanning. Scan the
following On barcode to use character deactivation, then use Deactivation
Character (following) to select the character you will send from the host to
terminate scanning.

Deactivation Character

This sets the character used to terminate scanning when using Character
Deactivation Mode. On the
find the hex value that represents the character you want to use to terminate
scanning. Scan the following barcode, then use the
beginning on page 211239 to read the alphanumeric combination that
represents that ASCII character. Scan Save to finish.

Illumination Lights

If you want the illumination lights on while reading a barcode, scan the Lights On
barcode, below. However, if you want to turn just the lights off, scan the Lights
Off barcode.
Note: This setting does not affect the aimer light. The aiming light can be set using
Mode
36
Default = Off.
* Off
Default = Lights On.
(page 47).
* Lights On
Character Activation Timeout
ASCII Conversion Chart (Code Page
Deactivation Character
On
1252), page 207,
Programming Chart,
Default = 14 [DC4].
Lights Off
HH490 User Guide
Aimer