Addenda Timeout; Upc-E0 Addenda Separator; Upc-E0 Check Digit - Honeywell HH490 User Manual

Addenda Timeout

You can set a time during which the scanner looks for an addenda. If an addenda
is not found within this time period, the data can be either transmitted or
discarded, based on the setting you are using for
the length (in milliseconds) for this timeout by scanning the barcode below, then
setting the timeout (from 0-120 milliseconds) by scanning digits from the
Programming Chart,
120.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.

UPC-E0 Addenda Separator

When this feature is On, there is a space between the data from the barcode and
the data from the addenda. When turned Off, there is no space.

UPC-E0 Check Digit

Check Digit specifies whether the check digit should be transmitted at the end of
the scanned data or not.
106
beginning on page 211 of this manual, then Save.
* On
Default
* On
UPC-E0 Addenda
Addenda Timeout
On.
=
Required. Set
Default =
Default On.
=
Off
Off
HH490 User Guide