Activation Character; Character Activation Laser Timeout; Character Deactivation Mode; End Character Activation After Good Read - Honeywell Vuquest 3310g User Manual

Activation Character

This sets the character used to trigger scanning when using Character Activation Mode. On the
(Code Page 1252), page A-3, find the hex value that represents the character you want to use to trigger scanning. Scan
the following bar code, then use the
character. Scan Save

Character Activation Laser Timeout

You can set a timeout for the length of time the laser remains on and attempting to decode bar codes when using Character
Activation Mode. Set the length (in milliseconds) for a timeout by scanning the following bar code, then setting the timeout
(from 1-65535 milliseconds) by scanning digits from the

Character Deactivation Mode

If you have sent a character from the host to trigger the scanner to begin scanning, you can also send a deactivation character
to stop scanning. Scan the following On bar code to use character deactivation, then use Deactivation Character (following) to
select the character you will send from the host to terminate scanning. Default = Off.
* Off

End Character Activation After Good Read

After a bar code is successfully detected and read from the scanner, the illumination can be programmed either to remain
on and scanning, or to turn off. When End Character Activation After Good Read is enabled, the illumination turns off
and stops scanning after a good read. If you scan Do Not End Character Activation After Good Read, the illumination
remains on after a good read. Default = End Character Activation After Good Read.
Do Not End Character Activation
After Good Read
Programming Chart
to finish.
Activation Character
Character Activation Laser
to read the alphanumeric combination that represents that ASCII
Programming Chart, then scanning Save. Default = 5000 ms.
Timeout
ASCII Conversion Chart
On
* End Character Activation After
Good Read
3 - 11