Activation Character; End Character Activation After Good Read; Character Activation Timeout - Honeywell HH490 User Manual

Activation Character

This sets the character used to trigger scanning when using Character Activation
Mode. On the
value that represents the character you want to use to trigger scanning. Scan the
following barcode, then use the
combination that represents that ASCII character. Scan Save to finish.
12 [DC2].

End Character Activation After Good Read

After a barcode is successfully detected and read from the scanner, the
illumination can be programmed either to remain on and scanning, or to turn off.
When End Character Activation After Good Read is enabled, the illumination
turns off and stops scanning after a good read. If you scan Do Not End
Character Activation After Good Read, the illumination remains on after a good
read.
Do Not End Character Activation

Character Activation Timeout

You can set a timeout for the length of time the illumination remains on and
attempting to decode barcodes when using Character Activation Mode. Set the
length (in milliseconds) for a timeout by scanning the following barcode, then
setting the timeout (from 1-300,000 milliseconds) by scanning digits from the
Programming Chart,
HH490 User Guide
* Off
ASCII Conversion Chart (Code Page
After Good Read
beginning on page 211239, then Save.
1252), page 207, find the hex
Programming Chart
Activation Character
On
to read the alphanumeric
Default =
End Character Activation After
Good Read
Default = 30,000 ms.
35