Addenda Timeout; Coupon Gs1 Databar Output; Upc-E0 - Honeywell HH490 User Manual

Addenda Timeout

You can set a time during which the scanner looks for an addenda. If an addenda
is not found within this time period, the data can be either transmitted or
discarded, based on the setting you are using for
Coupon
barcode below, then setting the timeout (from 0-120 milliseconds) by scanning
digits from the
Save.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.

Coupon GS1 DataBar Output

If you scan coupons that have both UPC and GS1 Databar codes, you may wish to
scan and output only the data from the GS1 Databar code. Scan the GS1 Output
On code below to scan and output only the GS1 Databar code data.
Output Off.

UPC-E0

104
Code. Set the length (in milliseconds) for this timeout by scanning the
Programming Chart,
Default = 120.
* GS1 Output Off
beginning on page 211 of this manual, then
Addenda Timeout
<Default All UPC-E Settings>
UPC-A/EAN-13 with Extended
Default
GS1 Output On
HH490 User Guide
GS1
=