Intercharacter Delay; User Specified Intercharacter Delay - Honeywell HH490 User Manual

Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each character of scanned data. Scan the
Intercharacter Delay barcode below, then scan the number of 5ms delays from
the
To remove this delay, scan the Intercharacter Delay barcode, then set the
number of delays to 0. Scan the Save barcode from the
beginning on page 211.
Note: Intercharacter delays are not supported in USB serial emulation.

User Specified Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length barcode below, then scan the number of 5ms delays from the
Programming Chart,
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for
a printable character to trigger the delay (see
205.
To remove this delay, scan the Delay Length barcode, and set the number of
delays to 0. Scan the Save barcode from the
page 211.
HH490 User Guide
Programming Chart,
Prefix
beginning on page 211, then Save.
)
Delay Length
beginning on page 211, then Save.
Scanned Data Suffix
1 2 3 4 5
Intercharacter Delay
Intercharacter Delay
Programming Chart,
Lower ASCII Reference Table,
Character to Trigger Delay
Programming Chart,
page
beginning on
57