Character Deactivation; Deactivation Character; Illumination Lights; Aimer Delay - Honeywell HH1800 User Manual

Character Deactivation

If you have sent a character from the host to trigger the scanner to begin scanning, you can
also send a deactivation character to stop scanning. Scan the following On barcode to use
character deactivation, then use Deactivation Character (following) to select the character
you will send from the host to terminate scanning. Default = Off.

Deactivation Character

This sets the character used to terminate scanning when using Character Deactivation Mode.
On the
the character you want to use to terminate scanning. Scan the following barcode, then use
the
that represents that ASCII character. Scan Save to finish. Default = 14 [DC4].

Illumination Lights

If you want the illumination lights on while reading a barcode, scan the Lights On barcode,
below. However, if you want to turn just the lights off, scan the Lights Off barcode. Default =
Lights On.
Note: This setting does not affect the aimer light. The aiming light can be set using
(page 47).

Aimer Delay

The aimer delay allows a delay time for the operator to aim the scanner before the picture is
36
* Off
ASCII Conversion Chart (Code Page
Programming Chart, beginning on page 211239 to read the alphanumeric combination
* Lights On
Character Activation Timeout
1252), page 207, find the hex value that represents
Deactivation Character
On
Aimer Mode
Lights Off
HH1800 User Guide