Other Programming Selections - Honeywell HH490 User Manual

Note: 99 indicates all symbologies.
Step 5. Length
Note: 9999 indicates all lengths.
Step 6. Editor Commands
Step 7. Scan Save to save your data format, or Discard to exit without saving

Other Programming Selections

•
•
HH490 User Guide
If you are creating a data format for Batch Mode Quantity, use 35 for the
Code I.D.
Specify what length (up to 9999 characters) of data will be acceptable for
this symbology. Scan the four digit data length from the
Chart, beginning on page 211. For example, 50 characters is entered as
0050.
Refer to Data Format Editor Commands
that represent the command you want to enter.
your changes.
Enter Data Format
Discard
Clear One Data Format
This deletes one data format for one symbology. If you are clearing the
primary format, scan 0 from the
211. If you are clearing an alternate format, scan 1, 2, or 3, depending on
the format you are clearing. Scan the Terminal Type and Code I.D. (see
Symbology Charts
specific data format that you want to delete. All other formats remain
unaffected.
Clear all Data Formats
This clears all data formats.
Programming Chart,
on page 200), and the barcode data length for the
Programming
(page 62). Scan the symbols
Save
beginning on page
61