End Character Activation After Good Read; Character Activation Laser Timeout; Character Deactivation Mode; Deactivation Character - Honeywell Voyager 1450g Series User Manual

End Character Activation After Good Read

After a bar code is successfully detected and read from the scanner, the laser can be programmed either to remain on and
scanning, or to turn off. When End Character Activation After Good Read is enabled, the laser turns off and stops scan-
ning after a good read. If you scan Do Not End Character Activation After Good Read, the laser remains on after a good
read. Default = End Character Activation After Good Read.
Do Not End Character Activation
After Good Read

Character Activation Laser Timeout

You can set a timeout for the length of time the laser remains on and attempting to decode bar codes when using Character
Activation Mode. Set the length (in milliseconds) for a timeout by scanning the following bar code, then setting the timeout
(from 1-65535 milliseconds) by scanning digits from the

Character Deactivation Mode

If you have sent a character from the host to trigger the scanner to begin scanning, you can also send a deactivation character
to stop scanning. Scan the following On bar code to use character deactivation, then use Deactivation Character (following) to
select the character you will send from the host to terminate scanning. Default = Off.
* Off

Deactivation Character

This sets the character used to terminate scanning when using Character Deactivation Mode. On the
Chart (Code Page 1252), page A-3, find the hex value that represents the character you want to use to terminate scanning.
Scan the following bar code, then use the
ASCII character. Scan
4 - 12
Character Activation Laser
Programming Chart
Save to finish.
Deactivation Character
Programming Chart, then scanning Save. Default = 5000 ms.
Timeout
to read the alphanumeric combination that represents that
* End Character Activation After
Good Read
On
ASCII Conversion