Chapter 9 - Serial Programming Commands; Conventions; Menu Command Syntax - Honeywell HH490 User Manual

CHAPTER
9
CHAPTER 9 -
COMMANDS
The serial programming commands can be used in place of the programming
bar- codes. Both the serial commands and the programming barcodes will
program the scanner. For complete descriptions and examples of each serial
programming command, refer to the corresponding programming barcode in
this manual.
The device must be set to an RS232 interface (see
mands can be sent via a PC COM port using terminal emulation software.

Conventions

The following conventions are used for menu and query command descriptions:
parameter
option
[
{Data}
bold

Menu Command Syntax

Menu commands have the following syntax (spaces have been used for clarity
only):
Prefix [:Name:] Tag SubTag {Data} [, SubTag {Data}] [; Tag SubTag {Data}] [...]
Storage
Prefix
:Name:
HH490 User Guide
SERIAL PROGRAMMING
A label representing the actual value you should send as part of a
command.
] An optional part of a command.
Alternatives in a command.
Names of menus, menu commands, buttons, dialog boxes, and
win- dows that appear on the screen.
Three ASCII characters: SYN M CR (ASCII 22,77,13).
This command is only used with cordless devices. It is used to
specify whether you're communicating with the base or the
scanner. To send information to the scanner (with the base
page 7). The following com-
163