Chapter 5 - Data Format; Data Format Editor Introduction - Honeywell HH490 User Manual

CHAPTER
5
CHAPTER 5 -

Data Format Editor Introduction

You may use the Data Format Editor to change the scanner's output. For example,
you can use the Data Format Editor to insert characters at certain points in
barcode data as it is scanned. The selections in the following pages are used only
if you wish to alter the output.
Normally, when you scan a barcode, it is output automatically. However, when
you create a format, you must use a "send" command (see
page 63) within the format program to output data.
Multiple formats may be programmed into the scanner. They are stacked in the
order in which they are entered. However, the following list presents the order in
which formats are applied:
1. Specific Terminal ID, Actual Code ID, Actual Length
2. Specific Terminal ID, Actual Code ID, Universal Length
3. Specific Terminal ID, Universal Code ID, Actual Length
4. Specific Terminal ID, Universal Code ID, Universal Length
5. Universal Terminal ID, Actual Code ID, Actual Length
6. Universal Terminal ID, Actual Code ID, Universal Length
7. Universal Terminal ID, Universal Code ID, Actual Length
8. Universal Terminal ID, Universal Code ID, Universal Length
The maximum size of a data format configuration is 2000 bytes, which includes
header information.
If a barcode is read that fails the first data format, the next data format, if there is
one, will be used on the barcode data. If there is no other data format, the raw
data is output.
HH490 User Guide
DATA FORMAT
Default Data Format setting = None.
Send Commands on
59