Chapter 3 - Input/Output Settings; Power Up Beeper; Beep On Bel Character - Honeywell HH490 User Manual

CHAPTER
3
CHAPTER 3 -

Power Up Beeper

The scanner can be programmed to beep when it's powered up. If you are using a
cordless system, the base can also be programmed to beep when it is powered
up. Scan the Off barcode(s) if you don't want a power up beep.
Beeper On - Scanner.
Power Up Beeper Off - Scanner

Beep on BEL Character

You may wish to force the scanner to beep upon a command sent from the host.
If you scan the Beep on BEL On barcode below, the scanner will beep every time
a BEL character is received from the host.
HH490 User Guide
INPUT/OUTPUT SETTINGS
*Beep on BEL Off
Default = Power Up
* Power Up Beeper On -
Default = Beep on BEL Off.
Scanner
Beep on BEL On
23