Character Activation Laser Timeout; Character Deactivation Mode; End Character Activation After Good Read - Honeywell Vuquest 3310g User Manual

Character Activation Laser Timeout

You can set a timeout for the length of time the laser remains on and
attempting to decode bar codes when using Character Activation Mode.
Set the length (in milliseconds) for a timeout by scanning the following bar
code, then setting the timeout (from 1-65535 milliseconds) by scanning dig-
its from the Programming

Character Deactivation Mode

If you have sent a character from the host to trigger the scanner to begin scan-
ning, you can also send a deactivation character to stop scanning. Scan the fol-
lowing On bar code to use character deactivation, then use Deactivation
Character (following) to select the character you will send from the host to termi-
nate scanning. Default = Off.
* Off

End Character Activation After Good Read

After a bar code is successfully detected and read from the scanner, the
illumination can be programmed either to remain on and scanning, or to
turn off. When End Character Activation After Good Read is enabled,
the illumination turns off and stops scanning after a good read. If you scan
Do Not End Character Activation After Good Read, the illumination
remains on after a good read. Default = End Character Activation After
Good Read.
Do Not End Character Activation
After Good Read
3 - 14
Chart, then scanning Save. Default = 5000 ms.
Character Activation Laser
Timeout
On