Control Character Output; Keyboard Modifiers - Honeywell HH490 User Manual

Control Character Output

This selection sends a text string instead of a control character. For example,
when the control character for a carriage return is expected, the output would
display [CR] instead of the ASCII code of 0D. Refer to
(Code Page 1252)
column of the chart).
Note: Control + X (Control + ASCII) Mode overrides this mode.
Control Character Output On

Keyboard Modifiers

This modifies special keyboard features, such as CTRL+ ASCII codes and Turbo
Mode.
Control + X (Control + ASCII) Mode On: The scanner sends key combinations for
ASCII control characters for values 00-1F. Windows is the preferred mode. All
keyboard country codes are supported. DOS mode is a legacy mode, and it does
not support all keyboard country codes. New users should use the Windows mode.
Refer to
Windows Mode Prefix/Suffix Off: The scanner sends key combinations for ASCII
control characters for values 00-1F, but it does not translate prefix or suffix
information.
Support ALT 3 Digit HEX Mode: The scanner sends key combinations for ASCII
control characters for values 00-1F transmitted as the ALT key and 3 digits.
HH490 User Guide
* Keyboard Conversion Off
Convert All Characters to
Lower Case
on page 207. Only codes 00 through 1F are converted (the first
Default = Off.
ASCII Conversion Chart (Code Page
Convert All Characters to
ASCII Conversion Chart
* Control Character Output Off
1252), page 207 for CTRL+ X Values.
Upper Case
17