Remote Control Selection - GE Voluson P8 BT16 Basic Service Manual

GE RAFT
DIRECTION 5723243, R
3-7-8

Remote Control Selection

To assign an auxiliary device (e.g., printer) to the remote keys P1, P2, and/or P3
1.) Press the UTILITIES key on the control console.
2.) In the "Utilities" menu select SETUP button to invoke the setup desktop on the screen.
3.) On the right side of the screen select CONNECTIVITY and then click the
tab.
1
2
Figure 3-55 System Setup - Connectivity - BUTTON CONFIGURATION page (Overview)
1 Overview
1a Configure buttons
1b Selected Printer
1c Recorder Control
1d Select P1 to send Email
Overview tab:
•
NOTE: Optionally the Printer Remote Control can be done by the Foot switch.
(refer to:
Detailed Setup tab:
•
-
3-52
6 DRAFT (M
EVISION
2 Detailed Setup
A.) Configure "Remote" Buttons: Select the desired remote control button.
B.) Select Printer: Check mark and select the desired Printer for the remote control button.
C.) Recorder Control: Check mark this item to use the selected P? key for Recorder Control.
D.) Check mark "Use P? key to send Email", and adjust Settings.
Figure 3-49: System Setup - Connectivity - PERIPHERALS page on page
If it is desired, check mark "Use Report Printer for Reports"
Section 3-7 - Printer Installation
23, 2018)
AY
V ™ P8 / V
OLUSON OLUSON
B S M
ASIC ERVICE
BUTTON CONFIGURATION
1a
1b
1c
1d
3-47)
™ P6
ANUAL