GE Voluson P8 BT16 Basic Service Manual page 98

GE RAFT
DIRECTION 5723243, R
NOTE: The mains outlet of the system for peripheral auxiliary equipment are commonly switched with the
ON/OFF button. So the auxiliary equipment need not to be switched ON/OFF separately.
WARNING WARNING Disconnection of the Main Power Cable is necessary!
For Example: When repairing the system.
!! WARNING:
5.) After complete power down, disconnect the main power cable from the system or unplug it from the
AC wall outlet socket.
6.) Press on the brakes to block the front caster wheels.
7.) Disconnect probes. (Turn the probe locking handle counterclockwise and then pull the connector
straight out of the probe port.)
DO NOT disconnect a probe while running (Live Scan "Write" mode)!
CAUTION
A software error may occur. In this case switch the unit OFF (perform a reset).
!! CAUTION:
3-30
6 DRAFT (M
EVISION
Figure 3-18 Circuit and main power at rear of system
Section 3-6 - Completing the Set Up
23, 2018)
AY
Circuit
Main Power
V ™ P8 / V
OLUSON OLUSON
B S M
ASIC ERVICE
™ P6
ANUAL