GE
DRAFT
DIRECTION 5723243, R
3-7-3
Installing the Network Color laser Printer
1.) Power off/Shutdown the system as described in
2.) Connect the printer as described in
3.) Power On/Boot Up the system as described in
4.) Press the Power On button on the printer.
5.) Install ink tanks and load paper.
6.) Wait until the printer displays Ready.
7.) By means of the Printer Controls Left<, Right> and OK set the TCP/IP address to Automatic.
8.) Press the Back button until the Printer displays Ready again.
9.) By means of the Printer Controls Left<, Right> and OK print out the Config Report.
6
DRAFT (M
EVISION
Figure 3-20 printer controls
1. Power ON
2. Display
3. Status Indicators
4. Cancel
Figure 3-21 TCP/IP Config - Automatic
Figure 3-22 Reports -> Config Report
Chapter 3 - Setup Instructions
23, 2018)
AY
Section 3-6-3 on page 3-29
page 3-16
Section 3-6-2 on page 3-25
5. Right >
6. OK
7. Left <
8. Back
V
™ P8 / V
OLUSON
OLUSON
B
S
M
ASIC
ERVICE
™ P6
ANUAL
3-33