Refreshing A Wlan Network; Setting A Wlan Network As Non-Preferable - GE Voluson P8 BT16 Basic Service Manual

GE RAFT
DIRECTION 5723243, R
5.) Select the Security tab and then click Add.
6.) Add the following information to the Wireless Network Properties page:
-
-
-
-
-
-
7.) After you have filled in all the required information, click OK.
3-13-2-4

Refreshing a WLAN Network

1.) Press the "Utilities" key on the control console.
2.) On the right side of the screen select Connectivity and then click the Device Setup tab.
3.) Click the WLAN Configuration button; see
4.) The Wireless Network Configuration tool with available Wireless Networks appear.
5.) Click Refresh.
3-13-2-5

Setting a WLAN Network as Non-Preferable

When you make a WLAN non-preferable, you disconnect the network from the system and delete all
connection settings from the system. Afterwards the system WILL NOT try to reconnect to this WLAN
automatically. And if you want to reconnect, you will need to re-add this WLAN.
1.) Press the "Utilities" key on the control console.
2.) On the right side of the screen select Connectivity and then click the Device Setup tab.
3.) Click the WLAN Configuration button; see
4.) The Wireless Network Configuration tool with available Wireless Networks appear.
5.) Highlight the wireless network you want to set as non-preferred.
6.) Click Make Non-Preferable and cinfirm the message box.
3-78
6 DRAFT (M
EVISION
Figure 3-79 Security - Add
Network Name(SSID)
Check box " Connect even if Network is not Broadcasting its Name (SSID)"
network Authentication (Open, Shared key, WPA PSK or WPA2 PSK)
Date Encryption
Network Key
Key Index
Section 3-13 - Network Configuration
23, 2018)
AY
Section Figure 3-76 on page 3-75
Section Figure 3-76 on page 3-75
V ™ P8 / V
OLUSON OLUSON
B S M
ASIC ERVICE
™ P6
ANUAL