Remote Control Selection - GE Voluson E Series Service Manual

3.6.7 Remote Control Selection

To assign an auxiliary device (e.g., printer) to the remote keys P1, P2, P3 and/or P4:
1. Press the Utilities key on the control console.
2. In the "Utilities" menu touch the
3. On the left side of the screen select
1 Overview
1a Configure buttons
1b Select Printer
1c Recorder Control
1. Overview tab:
a. Configure "Remote" Buttons: Select the desired remote control button.
b. Select Printer: Check mark and select the desired Printer for the remote control button.
c. Recorder Control: Check mark this item to use the selected P? key for Recorder Control.
Optionally the Printer Remote Control can be done by the Foot switch; see
Note
2. Detailed Setup tab:
a. If it is desired, check mark "Use Report Printer for Reports"
3.6.7.1 Report Printer Selection
1. Click on the
2. Select the desired Report Printer from the pull-down menu.
The selected Report Printer is usually used for printing reports and images from the Archive.
Note
Voluson E-Series Service Manual
KTD106657 Revision 2
System Setup button to invoke the setup desktop on the screen.
Connectivity and then click the Button Configuration tab.
Figure 3-59 System Setup - Connectivity - BUTTON CONFIGURATION page (Overview)
Peripherals tab; see Figure 3-49 on page 3-50
2 Detailed Setup
Figure 3-49 on page 3-50
.
Setup Instructions
.
3-57