Power-On Inspection; Connect The Probe; Function Inspection - SIGLENT SDS1000X-E Series User Manual

SDS1000X-E&SDS1000X-U User Manual
2-channel scope

Power-on Inspection

When the oscilloscope is energized, press the power key at the lower-left corner of
the front panel to start the oscilloscope. During the start-up process, the
oscilloscope performs a series of self-tests and you can hear the sound of relay
switching. After the self-test is finished, the welcome screen is displayed.

Connect the Probe

Connect the Probe:
1. Connect the BNC terminal of the probe to a channel BNC connector of the
oscilloscope at the front panel.
2. Connect the probe tip to the circuit point to be tested and connect the ground
alligator clip of the probe to the circuit ground terminal.

Function Inspection

1. Press the Default button on the front panel to restore the instrument to its
default configuration.
2. Connect the ground alligator clip of the probe to the "Ground Terminal"
under the probe compensation signal output terminal.
2-channel scope
Figure 6 To Connect to Power Supply
6
4-channel scope
WWW.SIGLENT.COM