SIGLENT SDS1000X-E Series User Manual page 164

SDS1000X-E&SDS1000X-U User Manual
Press Markers Control softkey to enter MARKER Menu.

a. Press the Marker softkey continuously to select the marker number
from NO.1~NO.8.
b. Press the Show Marker softkey continuously to turn on or off the
selected mark.
c. Press the Frequency softkey to set the frequency value of the selected
marker.
d. Press the Next Peak softkey to move the selected mark to the next peak.
And press the Next Amplitude softkey to move the selected marker to
the next peak with lower amplitude.(Up to 10 peaks are supported)
Press the Search Config softkey to enter the SEARCH menu. Similar to the

search configuration for peak markers.
Press the Markers on Peaks softkey to set the markers on peaks, and press

the Markers on harmonics softkey to set the markers on harmonics.
Press the Show Table softkey to show the amplitude of the markers; press

the Show Frequency softkey to show the frequency value of the markers,
and press the Show Delta softkey to show the delta amplitude between
markers.
The following figure shows the FFT waveform displayed on the split screen and the
peak tool is turned on:
Figure 78 FFT Markers Menu
Figure 79 Marker Control Menu
132
WWW.SIGLENT.COM