Systems - SIGLENT SDS1000X-E Series User Manual

SDS1000X-E&SDS1000X-U User Manual
Press Utility→NextPage4/4→AWG→ Setting→ OVP to turn on or off the function. If
the state is set to ON, overvoltage protection of AWG output port take effect once
the condition is meeting (the absolute value of input voltage is higher than
4V±0.5V). When overvoltage protection occurs, a message will be displayed and
the output is disabled.
Default
Press Utility →NextPage4/4→ AWG→ Setting→ Default to recover the default
values of AWG (Sine, 1.000 KHz, 4.000Vpp, 0.0mVdc, High-Z, Sync output off, OVP
On).
Zero Adjust
Press Utility→ NextPage4/4→ AWG→ Setting→ Zero Adjust. The AWG can be
calibrated by using Auto mode or Manual mode. The adoption standard of AWG
calibrated is: when AWG outputs 0V DC signal, the corresponding channel at
1mv/div gear' mean value of oscilloscope is rang in ±1mv.
Auto mode: This mode can only be performed with the channel1 of

oscilloscope. Connect the output of AWG to the oscilloscope'channel1, press
the Auto soft key, then the AWG starts to automatic calibrate, and
displays "Zero Adjust Success!".
Manual mode: The AWG can be manually calibrated through any channel on

the oscilloscope.
Take channel 2 as an example:
a. Connect the output of AWG to the oscilloscope' channel 2, open the
channel 2, and set DC coupling, open bandwidth limit, Probe is 1X.
b. Adjust the voltage of channel 2 channel to 1mv/div, and make the
waveform visible in the oscilloscope interface, press the Measure and
measure the mean value of channel 2.
c. Press the Manual and rotate the knob to adjust the waveform, so that the
mean value of the observed CH2 will be in the range of ±1mv, and then
press the Save, the oscilloscope displays "Zero Adjust Success!".

Systems

System Status
Press Utility→NextPage4/4→AWG→System, then select the System Status option to
view the AWG's system information, including software version, hardware version,
190
WWW.SIGLENT.COM