Keyboard Test; Led Test - SIGLENT SDS1000X-E Series User Manual

SDS1000X-E&SDS1000X-U User Manual

Keyboard Test

Keyboard test is used to test that if the keys or the knobs work well.
Do the following steps to do keyboard test:
1. Press the Utility button on the front panel to enter the UTILITY function menu.
2. Press the Next Page softkey to go to the second page of the UTILITY function
menu.
3. Press the Next Page softkey to go to the third page of the UTILITY function
menu.
4. Press the Do Self Test softkey to enter the SELFTEST function menu.
5. Press the Keyboard Test softkey to enter the keyboard test interface, as the
picture shown below.
6. To perform the knobs and the buttons test.
7. Knobs test: the default value is 0. Turn left to increase the value while turn right
to decrease; push the knob to set the value to 0. Test every knob randomly.
8. Keys test: the first time to press the key to light it up, and a second press to die
out. Test every button randomly.
9. Press the Run/Stop button 3 times to exit the keyboard test program.

LED Test

LED test is used to test that if the button lights work well.
Figure 123 Keyboard Test
199
WWW.SIGLENT.COM