SIGLENT SDS1000X-E Series User Manual page 46

SDS1000X-E&SDS1000X-U User Manual
Figure 13 SDS1000X-U Scope Rear panel Overview
1. Handle
Pull up the handle vertically for easy carrying of the instrument. When you do
not need the handle, press it down.
2. Safety lock Hole
You can lock the instrument to a fixed location using the security lock (please
buy it yourself) via the lock hole.
3. LAN
The instrument can be connected to network via this interface to perform
remote control.
4. USB Device
The oscilloscope support SCPI remote control commands, user can control the
oscilloscope through this interface
5. Pass/Fail or Trigger Out
The BNC port can output a signal that reflects the current waveform capture
rate of the oscilloscope at each trigger or a pass/fail test pulse.
6. AC Power Socket
AC power input terminal. The power requirements of this oscilloscope are
100-240 V, 50/60/400 Hz. Use the power cord provided with the instrument to
connect it to AC power.
14
WWW.SIGLENT.COM