SIGLENT SDS1000X-E Series User Manual page 11

SDS1000X-E&SDS1000X-U User Manual
to its operating conditions.
Disconnect the instrument from all power sources, and then clean it with a soft wet cloth.
Clean the loose dust on the outside of the instrument and probe with a soft cloth. When
cleaning the LCD, take care to avoid scarifying it.
WARNING
To avoid damages to the surface of the instrument and probe, please do not
use any corrosive liquid or chemical cleanser.
WARNING
Make sure that the instrument is completely dry before restarting it to avoid
short circuits or personal injuries.
Safety Compliance
This section lists the safety standards with which the product complies.
U.S. nationally recognized testing laboratory listing
■ UL 61010-1:2012/R:2018-11. Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use – Part 1: General Requirements.
■ UL 61010-2-030:2018. Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use – Part2-030: Particular requirements for testing and
measuring circuits.
Canadian certification
■ CAN/CSA-C22.2 No. 61010-1:2012/A1:2018-11. Safety Requirements for Electrical
Equipment for Measurement, Control, and Laboratory Use –
Requirements.
■ CAN/CSA-C22.2 No. 61010-2-030:2018. Safety Requirements for Electrical Equipment
for Measurement, Control, and Laboratory Use – Part 2-030: Particular requirements for
testing and measuring circuits.
X
Part 1: General
WWW.SIGLENT.COM