Output; Wave - SIGLENT SDS1000X-E Series User Manual

SDS1000X-E&SDS1000X-U User Manual

Output

Connect AWG with USB cable, and the oscilloscope interface indicates "AWG device
connection success", Press the Utility →Next Page4/4→ AWG, to enter the function
menu interface of the AWG system as shown below, including: Output, Wave,
Setting, System, and Remove Device.
Press Output softkey to open or close the AWG output .When the output is on, the
upper right corner of the oscilloscope interface will displays the corresponding
waveform frequency and amplitude information of AWG output wave.

Wave

To set standard waveform
Press the Utility→ Next Page4/4→AWG → Wave Type, Rotate the Universal Knob to
the Sine wave. Then press the knob to select the interface shown as below:
The following table shows the waveform type and its corresponding characteristics.
Figure 113 AWG Menu Interface
Figure 114 Wave Type Interface
187
WWW.SIGLENT.COM