General Care And Cleaning - SIGLENT SDS1000X-E Series User Manual

SDS1000X-E&SDS1000X-U User Manual
polarized plug and a standard IEC320 (Type C13) connector for making line voltage and
safety ground connection. The AC inlet ground terminal is connected directly to the frame
of the instrument. For adequate protection against electrical shock hazard, the power cord
plug must be inserted into a mating AC outlet containing a safety ground contact. Use only
the power cord specified for this instrument and certified for the country of use.
WARNING
Electrical Shock Hazard!
Any interruption of the protective ground conductor within or outside of the
scope or disconnection of the safety ground terminal creates a hazardous
situation.
Intentional interruption is prohibited.
The position of the oscilloscope should allow easy access to the socket. To make the
oscilloscope completely power off, unplug the instrument power cord from the AC socket.
The power cord should be unplugged from the AC outlet if the scope is not to be used for
an extended period of time.
CAUTION
The outer shells of the front panel terminals (CH1, CH2, CH3, CH4, EXT) are
connected to the instrument's chassis and therefore to the safety ground.

General Care and Cleaning

Care
Do not store or leave the instrument in direct sunshine for long periods of time.
WARNING
To avoid damages to the instrument or probe, please do not leave them in fog,
liquid, or solvent.
Cleaning
Please perform the following steps to clean the instrument and probe regularly according
IX
WWW.SIGLENT.COM