SIGLENT SDS1000X-E Series User Manual page 220

SDS1000X-E&SDS1000X-U User Manual
According to the selected waveform, to set the waveform parameters through
Universal Knob and the corresponding function software under the menu.
Wave
Parameters
Type
Frequency/Period/Amplitude/Hi
Sine gh-Level/Offset/Low-Level
value.
Frequency/Period/Amplitude/Hi
Square gh-Level/Offset/Low-Level/Duty
value.
Frequency/Period/Amplitude/Hi
Ramp gh-Level/Offset/Low-Level/Sym
metry value.
Frequency/Period/Amplitude/Hi
pulse gh-Level/Offset/Low-Level/
Width/ Width Fine value.
Noise Stdev/ Mean value.
DC Offset value.
Frequency//Period/Amplitude/H
Arb igh-Level/Offset/Low-Level
value
To set Arb waveform
Press the Utility→Next Page4/4→AWG→Wave Type, then select the Arb, and it has
two types:
Stored Arb
Users can edit the Arb through the PC which has installed the EasyWave
software .Send the edited Arbot to the instrument through remote interface, or
read from the U disk which has stored the Arb. Choose Wave Type→ Arb→ Arb
Type→ Stored, enter the Stored Arb interface and invoke the waveform in the
external storage device.
Built-in Arb
Choose Wave Type→ Arb →Arb Type→ Built-in to enter the following interface,
Rotate the knob to move the cursor, press the knob to select to the desired
waveform, and then return back to Built-in waveform interface.
Frequency
Range
1uHz~25MHz
1uHz~10MHz
1uHz~300KH
z
1uHz~10MHz
188
Amplitude Offset
(High-Z) (High-Z)
4mV~6V ± 3.0V
4mV~6V ± 3.0V
4mV~6V ± 3.0V
4mV~6V ± 3.0V
± 3.0V
WWW.SIGLENT.COM