Digital Bus - SIGLENT SDS1000X-E Series User Manual

SDS1000X-E&SDS1000X-U User Manual

Digital Bus

Digital channels may be grouped and displayed as a bus, with each value
displayed at the bottom of the display in hex or binary. You can create up two
buses.
To configure and display each bus, do the following steps:
1. Press the Digital button on the front panel to open the DIGITAL function menu
and display the digital channel waveforms.
2. Press the Digital Bus softkey to enter the DIGITALBUS function menu.
3. Press the Bus Select softkey to select Bus1 or Bus 2.
4. Press the Display softkey to select On to display the bus at the bottom of the
display.
Under the DIGITAL function menu, press the Cannel Control softkey, turn

the Universal Knob to select such as DX, and then press the Dx softkey to
select On or Off to set the channel to be included or excluded in the bus.
Under the DIGITAL function menu, press the Channel Group softkey to

select On or Off to include or exclude all digital channels in this group.
Under the DIGITAL function menu, a status indicator is displayed in the

status line at the bottom of the display. Light blue shows the digital
channel is included in the bus while black shows it is excluded in the bus.
Under the DIGITAL function menu, press the System Display softkey to

select Binary or Hex to display the bus values.
The Sampling rate of digital channels is displayed at the right of the display.
Figure 106 DIGITALBUS Function Menu
174
WWW.SIGLENT.COM