SIGLENT SDS1000X-E Series User Manual page 56

SDS1000X-E&SDS1000X-U User Manual
6. Trigger Delay Label
Indicate the trigger delay on the waveform.
7. Frequency Counter
Display the frequency value of the trigger channel.
8. Sampling Rate/ Memory Depth
Display the current sampling rate and memory depth. Sa means the current
sampling rate and Curr means the current memory depth.
9. Trigger Setup
Trigger Type
display by the abbreviation when the name is too long to display.
Trigger source
display in different color.
Trigger condition
Trigger coupling
coupling mode: DC, AC, HF Reject, LF Reject.
Trigger level
knob to set the trigger to the 50% of the waveform amplitude automatically.
10. Channel Setup
Probe attenuation factor
the channel. Available probe attenuation factors: 0.1X, 0.2X, 0.5X,
1X ...properties 2000X, 5000X, 10000X.
Input impedance
Input impedance that available: 1MΩ.
Channel coupling
Channel coupling that available: DC, AC, and GND.
Vertical Scale
the Vertical Scale Knob to adjust the value.
11. Trigger Level Label
Display the position of trigger level, the color is the same to the trigger channel.
It can move from +4.5div to -4.5div of the screen center.
12. I/O status
Indicate that the USB Host is connected.
Indicate that the LAN port is connected.
Indicate that the LAN port is disconnected.
Indicate that the WLAN port is connected.
Indicate that the WLAN port is disconnected.
: display the current trigger type. The trigger type names
: display the currently trigger source. Different channels
: display the current trigger condition.
: display the current trigger coupling. Available trigger
: display the current value of trigger level. Push the
: display the current probe attenuation factor of
: display the current input impedance of the channel.
: display the current channel coupling of the channel.
: display the current vertical scale of the channel. Turn
24
WWW.SIGLENT.COM