Table 12-3 Parameters Of The Output Interface; Table 12-4 Pin Definitions Of The Input Interface - Raisecom RC3000-15 Hardware Description

Raisecom
RC3000-15 (P100R001) Hardware Description
Table 12-3 lists parameters of the output interface.

Table 12-3 Parameters of the output interface

Connector type
Insulation resistance
Maximum current
Maximum voltage
Short-circuited current
Interface PINs
Table 12-4 lists PIN definitions. Wherein, every 2 pins correspond to an input channel.
The input interface supports two modes: external passive on/off value input and external
active on/off value input, which can be configured through jumpers J5–J12 on the card. Each
input interface corresponds to 4 jumpers (J5–J8 for input interface 1 and J9–J12 for input
interface 2). Each jumper has 4 pins.
Take input interface 1 for example. In external passive on/off value input mode, short circuit
pin 1 and pin 2, pin 3 and pin 4 of J5–J8. In external active on/off value input mode, short
circuit pin 2 and pin 3 of J5–J8. Configurations of input interface 2 are the same. By default, 2
input interfaces are in external passive on/off value input mode.
Passive on/off value refers to that the external input control circuit of the interface is
not equipped with power supply and instead the interface uses the internal power
supply to form a closed loop. Active on/off value refers to that the external input
control circuit of the interface is equipped with power supply and so the interface can
form a closed loop without internal power supply.

Table 12-4 PIN definitions of the input interface

Interface
1
Parameter
PIN I/O
1 IN
2 GND
3 IN
4 IN
5 GND
6 GND
7 IN
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
Phoenix terminal
≥ 1000 MΩ (500 VDC)

AC: 8 A
 DC: 5 A

250 VAC

30 VDC
5 A
On/Off value input 1+
On/Off value input 1-
On/Off value input 2+
On/Off value input 3+
On/Off value input 3-
On/Off value input 2-
On/Off value input 4+
12 Telecontrol service cards
PIN definition
178