Leds; Table 5-5 Parameters Of The Ethernet Interface; Table 5-6 Leds On The Stm1 (B) Card - Raisecom RC3000-15 Hardware Description

Raisecom
RC3000-15 (P100R001) Hardware Description

Table 5-5 Parameters of the Ethernet interface

Connector type
Interface rate
Supported framelength
Duplex mode
Flow control
Wiring
Compliant standard

5.1.5 LEDs

Table 5-6 lists LEDs on the STM1 (B) card.

Table 5-6 LEDs on the STM1 (B) card

PWR
SYS
ACT
LOS
LOF
LNK/A
CT
Parameter
LED Color
Green Power LED
 Green: the power supply is normal.
 Off: the power supply is abnormal.
Green System status LED
 Blinking green: the system is working properly.
 Off: the system is working improperly.
Green Primary/Slave LED
 Green: when two STM1 cards are installed on the RC3000-15 (E),
this card is primary; when one STM1 card is installed on the
RC3000-15 (E), this LED keeps green.
 Off: when two STM1 cards are installed on the RC3000-15 (E),
this card is slave.
Red LOS alarm LED
 Red: Loss of Signal (LOS) alarms are generated.
 Off: no LOS alarms are generated.
Red LOF alarm LED
 Red: Loss of Frame (LOF) alarms are generated.
 Off: input LOF alarms are generated.
Green Ethernet link LED
 Green: Ethernet link interfaces are connected properly.
 Off: Ethernet link interfaces are disconnected or are improperly
connected.
 Blinking green: Ethernet link interfaces are receiving or sending
data.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
RJ45
10/100 Mbit/s auto-negotiation
1536 bytes
Full/Half duplex auto-negotiation

Support IEEE 802.3x flow control in full duplex.

Support backpressure flow control in half duplex.
Auto MDI/MDI-X
IEEE 802.3x, IEEE 802.3u, IEEE 802.1Q, and MSAN-126
Description
Description
5 SDH cards
40