Buttons; Leds; Table 4-9 Buttons On The Dxc Card (F.00); Table 4-10 Leds On The Dxc Card (F.00) - Raisecom RC3000-15 Hardware Description

Raisecom
RC3000-15 (P100R001) Hardware Description

4.1.5 Buttons

Table 4-9 lists buttons on the DXC card (F.00).

Table 4-9 Buttons on the DXC card (F.00)

–

4.1.6 LEDs

Table 4-10 lists LEDs on the DXC card (F.00).

Table 4-10 LEDs on the DXC card (F.00)

PWR
SYS
ACT
100M
(SNMP)
LNK/ACT
(SNMP)
100M
(NM-EXT)
Print Button
Buzzer
control
button
LED Color
Green
Green
Green
Green
Green
Green
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Status
MUTE In this status, when an alarm is being
generated, the buzzer is mute. You cannot
(Up)
change this status through software.
RING In this status, when an alarm is being
generated, the buzzer rings. You can shield this
(Down)
status through software.
Power LED
 Green: the power supply is normal.
 Off: the power supply is abnormal.
System status LED
 Blinking green: the system is working properly.
 Off: the system is working improperly.
Working mode LED
 Green: the card is the master.
 Off: the card is the slave.
SNMP interface rate LED
 Green: the Ethernet rate is 100 Mbit/s.
 Off: the Ethernet rate is 10 Mbit/s or the interface is
disconnected.
SNMP interface working LED
 Green: the SNMP interface is working properly.
 Off: the SNMP interface is disconnected or is working
improperly.
 Blinking green: the SNMP interface is receiving or
sending data.
NM-EXT interface rate LED
 Green: the NM-EXT interface is working at 100 Mbit/s.
 Off: the NM-EXT interface is working at 10 Mbit/s.
Description
Description
4 DXC cards
28