Dip Switch; Table 10-28 Leds On The Fe16E1 Card; Table 10-29 Configurations Of The Dip Switch On The Fe16E1 Card - Raisecom RC3000-15 Hardware Description

Raisecom
RC3000-15 (P100R001) Hardware Description

Table 10-28 LEDs on the FE16E1 card

PWR
SYS
100M
LNK/ACT
FDX

10.5.6 DIP switch

Table 10-29 lists configurations of the DIP switch on the FE16E1 card.

Table 10-29 Configurations of the DIP switch on the FE16E1 card

KEY1
KEY2
SW2 on the DIP switch is the global reset button. Press it with caution, because this
restarts the RC3000-15 globally.
LED Color
Green
Green
Green
Green
Green
SW1 Function
Configure
default
aggregation
mode for data.
Reserved
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Power LED
 Green: the power supply is normal.
 Off: the power supply is abnormal.
System status LED
 Blinking green: the system is working properly.
 Off: the system is working improperly.
FE electrical interface rate LED:
 Green: the FE electrical interface is working at 100
Mbit/s.
 Off: the FE electrical interface is working at 10 Mbit/s.
Link working LED
 Green: the link interface is working properly.
 Off: the link interface is disconnected or is working
improperly.
 Blinking green: the link interface is receiving or sending
data.
Duplex mode LED
 Green: the FE electrical interface is working in full duplex
mode.
 Off: the FE electrical interface is working in half duplex
mode.
Status
OFF Aggregating data to the FE electrical interface on
the front panel
ON Aggregating data to the Ethernet switching card
through the backplane
–
Description
Description
10 Data cards
152